no special tools needed, its a piece of cake. The only tricky part of the whole operation is popping the ball joints loose.

 

Thanks Robb, I will be attempting this repair this Sunday....I will let you know how it goes....

 

Good luck, jus be careful of the threads on the tie rods. I like to loosen the nuts, but leave them on a little so when I take a hammer to break the tie rod loose in case I miss I dont mess the threads up.

 

I think there is a specialty tool for removing ball joints. I think its called a pittman arm, or something like that, I can't remember now.

 

Just take a hammer and smack the knuckle where the tierod connects (after you have loosened the nut) You might have to hit it a couple of time but it will pop out. They do make a puller for it but this way is much easier and faster. Good luck.

 

QUOTE ("FendrBendr":3c38mdka)

I think there is a specialty tool for removing ball joints. I think its called a pittman arm, or something like that, I can't remember now.

Pickle Fork

 

Guys, the tie rod was easier than I thought it was going to be. The only problem I had was removing one of the lock nuts at the end of one side of the tie rod....I have to replace that nut, but other than that, it was easy.

Thanks guys....

JJ

 

[No message]