Honda Foreman Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
I recently bought a "winch upgrade kit" from Venom Products on Ebay

<a href="http://cgi.ebay.com/ebaymotors/UNIVERSA" target="_blank">http://cgi.ebay.com/ebaymotors/UNIVERSA ... dZViewItem</a>

Where did you mount the contacter?? The ONLY place I could find was on the lower, front frame between the bumper tubes and behind the skid plate. I don't think it's a good spot and would like ideas on a better place. It's on a 2005 Foreman TM. BTW, it DOES work fine but I'm worried that it's too exposed and liable to get wet all the time. [/url]
 

·
Registered
Joined
·
26 Posts
Discussion Starter · #3 ·
I thought about that, but it's a bit large and I hate cutting holes in the body to run the wires. It's about 4" long x 2 1/2 " wide and 2" tall.
 

·
Registered
Joined
·
26 Posts
Discussion Starter · #9 ·
Here's where Honda recommends mounting them ..

Would it be a good assumption that the Ranchers mount the same way ?? I have a 2001 and 2005 that I'm doing this weekend. If so I'll just use the same pictures that are here.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top