Honda Foreman Forums banner

WHEEL BEARING

2768 Views 5 Replies 4 Participants Last post by  mudlord
Just installed a new front wheel bearing. I got ripped off at the dealer because i had to pay 100$ for bearing and 2 seals. :oops: But that is my problem.Anyways ,do you put greese on those double rubber seals that go around the outside of the hub? And if you do what kind of greese do ya use?
1 - 6 of 6 Posts
QUOTE ("bubba")
Just installed a new front wheel bearing. I got ripped off at the dealer because i had to pay 100$ for bearing and 2 seals. But that is my problem.Anyways ,do you put greese on those double rubber seals that go around the outside of the hub? And if you do what kind of greese do ya use?
I assume you are talking about the seal around the eadge of the brake drum.

yes the space in between the grooves should be packed with a multipurpose grease. be sure to clean the area inside the drum of excess grease so it wont get on the shoes. I use a good quality wheel bearing grease on mine.

also just a little on the rubber O ring in the center of the drum

Happy trails
If you ride in alot of mud or water, I would use marine grease. It helps keep the water out of the seals. I have taken mine apart a few times after putting marine grease on it, and it seems to do a pretty good job!


WHAT $100.00 for bearings and seals!!!! I hope they used some KY!!
Thanks fellas. No Ky, and it still hurts. Checked out Royal distributing in Ontario and I can get front wheel bearings for 30$ plus shipping. :thumbup:
I went to the dealer for mine after they told me the price i told them to keep it. I got one off ebay that night for 40 dollors made by All Balls Racing it's held up so far. Allways check ebay 1st before going to the dealer, they allways screw you.
All Balls is a real good kit! Their bearings will last longer than most.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top