Honda Foreman Forums banner
1 - 7 of 15 Posts

· Registered
Joined
·
527 Posts
Discussion Starter · #1 ·
i just replaced both my front wheel bearings like 3-4 weeks ago and i noticed on our ride sunday that it seemed like something was popping in the front end...well i finally got around to checking it out and it seems like the left front bearing is gone again....am i correct or is there something else in that area that could make it feel bad....this p's me off to have it go out that quick....i am not that rough on it...
 

· Registered
Joined
·
527 Posts
Discussion Starter · #4 ·
i may check into both of those ideas tomorrow..i took the wheels off,the shocks off and moved everything around and couldnt find anything else to be the problem...i will look into those ideas tomorrow when i get up and moving around....
 

· Registered
Joined
·
527 Posts
Discussion Starter · #7 ·
i had to drive the old bearings out of both sides..i cleaned the knuckles up and had to drive the new ones back in..they just didnt fall in...i just dont know why they would go bad after just a short time....i went to the place where i got the Moose bearings from and asked him if i could get that set replaced and he basically told me no..i then proceeded to tell him i will never buy anything from his store again and would tell everyone i knew not to shop there...it might have been childish and done no good but it made me feel better....
 
1 - 7 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top