I just got finished replacing the front bearings(650 miles), 2 lower ball joints(busted boots)..and an Inner boot on the axle(busted). Due to the lift kit, the snap ring had sorta welded itself inside the inner cup...so that problem had to be addresed. I was just wondering what all you guys have broke or replaced on your 500...!!
ok this is what i can remmber at the time i might think of something later, wore out a set of 28" laws, broke front axle, 2 axle boots, 4 ball joints, new bearings, back left liftkit, 2 yokes, rear diff, rear drum seal, piston, crank, 1st gear in trans, and a gear shifter. also 2 sets of front breaks.
Darren, I think that takes the cake..!! You must run WFO..!!!lol
Everything that has worn out or broken on mine is because of nature of my riding ,,,and the mods. A stock honda will last a while if you dont ride water and mud like we do
Its been a while since I have posted...but here is an update for the last few months
Broke 2 axles (OEM)
1 yoke (u-joint)
1 Tie rod
About to replace bearings again and brake pads....you play you pay!!
The bike still runs like a champ and doesnt smoke.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Honda Foreman Forums
537.3K posts
43K members
Since 2005
Honda Foreman Forums: Discuss the latest Honda Foreman in our free Honda Foreman forums. Also talk about Honda's other ATV and UTV's including the Honda Rubicon, Honda Rincon, Honda Rancher and Honda Recon