Honda Foreman Forums banner

vent lines

5K views 9 replies 8 participants last post by  DirtKurt 
Just take one of those ones that go into the frame cut a little bit off go to the hardware store and find a multiple "t" fitting. All of those vents can be "t"ed into one line and run that up, then look under the seat find the carb vent get a barbed fitting and run that up. Plug the carb drain before you go into deep water and you should be good.

You might also want to (at the very least) put dielectric grease in the spark plug boot, and on the electrical connection on that weird looking thing attached to the frame by the right rear tire(regulator/rectifier). At the most put it on every electrical connection you can find

Then do deep
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top