glad to hear u got it going, what all did u end up changing?
up and runnin again
Finaly got the motor back in. Ran into so many stupid problems which made the whole process take about 7 hours. I hate workin on stuff!
1 - 8 of 8 Posts
had a new output shaft w/ new bearing + gasket set put in along with a new u-joint.
Glad to here you up and going again.
About time are you still going to the p-run?
Not sure yet, if the whole group goes I will still probably go but from the looks of it everyone is backing out.
QUOTE ("eurobro":1dvxoqqr)
not meNot sure yet, if the whole group goes I will still probably go but from the looks of it everyone is backing out.
QUOTE ("dano":3qigc5bm)
Well it will be about dang time we rode again! Where the heck have you been?
QUOTE ("eurobro":3qigc5bm)
not me[/quote]Not sure yet, if the whole group goes I will still probably go but from the looks of it everyone is backing out.
Well it will be about dang time we rode again! Where the heck have you been?
1 - 8 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda Foreman Forums
Honda Foreman Forums: Discuss the latest Honda Foreman in our free Honda Foreman forums. Also talk about Honda's other ATV and UTV's including the Honda Rubicon, Honda Rincon, Honda Rancher and Honda Recon
Full Forum Listing
Explore Our Forums
Recommended Communities
