Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,236 Posts
When you installed the new TP sensor did you adjust the TP sensor position so that the resistance between terminals A and B is 580 - 620 ohms and tighten the shear bolts until the bolt heads break off. Connect the TP sensor connector then initialize the ECM ..
 

·
Registered
Joined
·
1,236 Posts
Sometimes you will get a code and reset (cycle the key on & off) then you never get it again..If you got the TP code more than once chances are it is faulty .. If the bike it an 07 Honda should cover it under warranty or good will warranty if the orginal warranty has run out ...
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top