Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,444 Posts
i used 1.5" 45 street elbow, and some Plumber's Goop to make sure its sealed. The key is you have to use 22.5 degree elbows pretty much back to back to make that bend to get along the motor. If you want to use rigid tubing. Otherwise you can use flex and just pop out of the frame like Rav did.
 

·
Registered
Joined
·
3,444 Posts
I pretty much duplicated Robb's with a few couple modifacations. I did just remove the balck plastic trim from the side of the motore rather than tirming it and still having it buldge out.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top