Honda Foreman Forums banner

Snorkling the 500

2178 Views 6 Replies 4 Participants Last post by  muddin500
All you guys that have successfully snorkled your 500 foreman's what does yalls look like where it comes out of the airbox i aint tryed anything yet but was just curious to see what yalls looks like.
1 - 7 of 7 Posts
Tough place to get a pic of, but I used a shop vac hose and the end of it fit right into the stock rubber grommet on the airbox.
I BOUGHT MY SNORKEL FROM TRIANGLE ATV IT WORKS GREAT, EASY TO INSTALL AND IT LOOKS FACTORY. IT WAS ONLY 125 + SHIPPING
i used 1.5" 45 street elbow, and some Plumber's Goop to make sure its sealed. The key is you have to use 22.5 degree elbows pretty much back to back to make that bend to get along the motor. If you want to use rigid tubing. Otherwise you can use flex and just pop out of the frame like Rav did.
I like the way that robb's is not to noticeable from the side you know tuck up good the triangle kits from the pics i have seen take that plastic piece under the body out, i would just like to do it like that to look slicker
I pretty much duplicated Robb's with a few couple modifacations. I did just remove the balck plastic trim from the side of the motore rather than tirming it and still having it buldge out.
do you have a pic of what it looks like off the bike so that i can duplicate it the only thing i wont to do different from everybody else is attempt to make 2 risers to make it more even and have even thought about dueling the ehaust
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top