Honda Foreman Forums banner

snorkle problems

1431 Views 7 Replies 3 Participants Last post by  crazywhitebo
just put a custom snorkle 2", down to 1 1/2" over carb and into air box, i cant get it to run right , it pops and sputters a high rpm, i had a 165 main jet, and needle set on second slot from top, that's how i set it with the hmf exaust and it ran fine until i put the snorkle, now i have tried one bigger and one smaller jet and also tried adjusting the air fuel mix screw, and i'm having no luck at all, any suggestions would be greatly appreicated, thanks
1 - 3 of 8 Posts
maybe too much air.... try covering half of the snorkle with ur hand give it some gas.
im pretty sure im running at 175

come to think of it mine did the same thing.... it would start up and idle fine.... but when i ran it at full throttle it wasnt running correctly. try the 175. almost garantee that will fix ur problem
sweet site... how do u like that rzr?
im thinkin about gettin that as my next toy but i dont like the EFI
1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.