Honda Foreman Forums banner


1674 Views 3 Replies 2 Participants Last post by  ForeWOMAN450
I want to snorkel my 450 ES, but I don't want to cut the plastic and I don't want to have a pipe sticking up, does anyone have any suggestions about how I should go about doing this? What materials are best and things like that. I think that I want to run it up under my pod, just to get it a little but higher just in case. I don't plan on going that deep but sh*t happens.
1 - 4 of 4 Posts
Travis (Rubicon3303) snorkled his dad's bike without cutting holes. Go to:
<a href="" target="_blank"> ... =snorkeled</a>
It should be the same for your bike.
My stock snorkel is on the side of the exhaust. I didn't know if this would cause a problem or if I would need to go to the other side.
Maybe you could PM Rubicon3303 and ask him. I'm sure he could tell you!
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.