Honda Foreman Forums banner
1 - 11 of 74 Posts

· Registered
Joined
·
2,575 Posts

· Registered
Joined
·
2,575 Posts
I agree all bets are off when your upside down. The best thing you can do when you "swamp it" is to pull it out drian the airbox and carb. Maybe even stand it on end to drain the exhaust. Before you try to start it. A lot of people try to start their bike while pipe is underwater and end up hydro-locking the motor then they have to go through the hassle of pulling the plug and blowing that water out.
 

· Registered
Joined
·
2,575 Posts
The end in the frame near the stearing stem. Get some "T"s to tie the the rear diff and break together. then you can tie the front diff, and breaks together then you only have to route a couple llines to the handle bars. Just don't "T" the carb vent, run tham to the handle bars by themselves. They need to vent to the atmosphere.
 

· Registered
Joined
·
2,575 Posts
Yje stock needle only has one place to put the clip. You will need to order one from dynojet to get adjustability. You can get the entire jet kit for around $55.
 
1 - 11 of 74 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top