Honda Foreman Forums banner
1 - 1 of 4 Posts

· Registered
21 Posts
Discussion Starter · #1 ·
I just installed my snorkle and i used a 2 inch shop vac hose and run along the side and up to the rack because i didn't want to cut a hole in my plastic quite yet. My problem is that the motor melted my hose just a little. Is their anything i can put around the hose to keep it from melting or would it just be best to just redo it using pvc.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.