Honda Foreman Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
I installed my jet kit with no problems but now my bike seems to want to stall now. I turned the idle screw back out to 3 turns. The kit suggested 2.5 but it smelled like it was running hot. I pinched the small o ring on the choke plunger when I re installed it. Would this maybe causing it to run a bit rough? It chugs and tries to stall out. Almost like the choke is sticking or something. Any ideas would be appreciated.
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #3 ·
I just wanted to get a little more power out of my bike from adding a Dynojet jet kit and a K&N air filter. Do you need to have an aftermarket exhaust to put a jet kit in? I was thinking about getting one for it, but for now I just have the stock exhaust.
 

·
Registered
Joined
·
560 Posts
You need more air to go along with the extra gas from the bigger jet. Stock exhaust limits the amount of air that can flow thru your engine.
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #5 ·
So I am going to need to buy an aftermarket exhaust for the jet kit to work properly?
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #6 ·
So I am going to need to buy an aftermarket exhaust for the jet kit to work properly?
 

·
Registered
Joined
·
560 Posts
As far as I know Yes. If anyone has any other options I'm sure they will reply.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top