Honda Foreman Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,679 Posts
If you have inspected all the bearings out and didn't see anything worn or damaged. That only leaves the axle where it goes through the ring gear. Inspect the splines for wear. If they look good, grease the axle real good and stick it back in and see if that gets rid of the noise.

once the axle gets alittle wear on it from mud and dirt over the years, they tend to have alittle chatter. The grease will cure the noise for alittle while.

yes there is a special socket needed to remove the pinion nut. The one I have I made, so far it has worked great.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top