Honda Foreman Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hey guys,
Looking for some insight here. Following from the rear I could see the wheel was kinda tilted. So I replaced the bearing the first time. Everything seemed good and straight when I was done. Seated bearing all the way in the carrier, torqued nut to 101ft/lbs. the carrier on the end where the seal sits is slightly out of round, will that impact it?

Not sure if my hub is bad or…?? Any suggestions… tired of replacing this bearing.
 
1 - 2 of 2 Posts
Top