Honda Foreman Forums banner

Quick Question (pic)

1380 Views 3 Replies 3 Participants Last post by  aaron_c
This rubber line (pictured below) looks like it is pinched in there pretty tight, is it supposed to be like that or should I do something? This is on the left side of the engine. If you need more pics, I can get take some tomorrow (it's storming like crazy right now).

See less See more
1 - 4 of 4 Posts
my rubicon was like that and i just left it that way. if i am remembering right, that wire goes around the control motor. i think all you have to do is just move it up around the control motor to make some slack. i wouldnt worry about it though, mine was the same way.
It's the wire for the angle sensor ... A lot are pinched like that ...
Oh okay, thanks. I was just making sure it wasn't any sort of air/fluid line that needed to flow freely.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.