Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
Gotta rebuild the 01 450 Foreman and I'm pulling the motor to save myself about $400 in labor. I've disconected EVERYTHING just having problems removing the motor from the front and rear drive shaft. I was told that I could just slide the front end up about 2 inches and that would be enough to free it but I can't get it to slide up. EVERYONE PLEASE HELP! thanks.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top