Honda Foreman Forums banner

Power failure in ignition

1300 Views 2 Replies 2 Participants Last post by  Searcher
When I turn the key and press start, it makes a click sound and kills all power to the bike. I took seat off and plate off and played around with wires and it started working again and worked fine for hours. The battery cables are not lose. I can't figure out what could be causing this. Any ideas??

Searcher
1 - 3 of 3 Posts
Try taking the cables off of the battery and clean them up with a wire brush or scrape them clean with a pocket knife. Also clean the top of the post on the battery. I've had the same thing happen, and that's all it was for me.
I will try that this week Thanks.

Searcher
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top