Honda Foreman Forums banner
1 - 12 of 12 Posts

·
Registered
Joined
·
212 Posts
Discussion Starter · #1 ·
I need to install another toggle switch on my bike and can't figure where to put one. I already have one opposite of the key slot on the headlight pod, but am stuck on where another could go. Any ideas or thought would be grrrrrreat!

H4--- I hope you have some insite on this, as I am sure you have figured this out.
 

·
Registered
Joined
·
1,397 Posts
just below the headlight pod on the front fender plastic.I'll try to get you a picture tomorrow.
 

·
Registered
Joined
·
560 Posts
I've added several types of switches but I'm not familiar enough with the head light pod on the foremans to suggest a specific location. As Yooperforeman suggested you can use the front plastic as I have in this pic. Pretty much anywhere you can reach from the seat can be used. You may even be able to change your existing switch to a double pole or double throw or even a DPDT to control more than one function. Depending of course on if the accessories are always on at the same time(like 2 sets of lights) or ONLY used one at a time (like a front OR rear light or winch).
Sorry I couldnt be more specific. Post a pic of what you decide to do.
 

·
Registered
Joined
·
74 Posts
I've put one on the side of the headlight pod and that worked out good for me.
 

·
Registered
Joined
·
1,397 Posts
The picture that H4 posted is exactly where I'm talking about.Thanks,H4!
 

·
Registered
Joined
·
212 Posts
Discussion Starter · #6 ·
I will give that a shot. Where can those rubber covers be picked up? I got one in a kit, but would like to get some more.
 

·
Registered
Joined
·
560 Posts
QUOTE ("homie189":307eego2)
I will give that a shot. Where can those rubber covers be picked up? I got one in a kit, but would like to get some more.
Best bet would probably be at a marine or boating supply dealer.
 

·
Registered
Joined
·
212 Posts
Discussion Starter · #8 ·
I decided to go to the side of the pod, not much room elsewhere. I have the rubber covers ordered and will be here Monday (they are a pain to find)
 

·
Registered
Joined
·
333 Posts
QUOTE
I will give that a shot. Where can those rubber covers be picked up? I got one in a kit, but would like to get some more.
I just picked up some xtra covers at the local Lowes Hardware Store, They have them in stock, here in Utah anyway, they were black in color run about $3 per copy. ~ dawg
 

·
Registered
Joined
·
212 Posts
Discussion Starter · #10 ·
Dawg, I will have to check there in the morning. That would be awesome if someone local stocked them. What department did you find them in?
 

·
Registered
Joined
·
333 Posts
-------------------------------------------------------------------------

---------------------------------------------------------------------------

-----------------------------------------------------------------------------
Dawg, I will have to check there in the morning. That would be awesome if someone local stocked them. What department did you find them in?
Found em in the Electrical section by all the toggle switches. Each is attached/ sealed to a cardboard card on a peg.
good luck
 

·
Registered
Joined
·
212 Posts
Discussion Starter · #12 ·
Found them, thanks again! 3.88 for two, sure beats the local boat deals 4.99 each!!
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top