Honda Foreman Forums banner
1 - 2 of 2 Posts

· Registered
8 Posts
Discussion Starter · #1 ·
I'm having problems with the rear drive shaft. With both of the lifts on, it made the shaft to short and it slips out the rear end when suspention is fully extended. (ex. holding break and burning out)
I had the driveshaft extended a 1/2" and the weld broke the first hour on the bike.
Any sugestions?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.