Honda Foreman Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter · #1 ·
First of all I'd like to say thanks to everyone who's contributed to this forum. I've saved a ton of money and learned alot from you guys. My hats off to everyone.

Has anyone fixed an oil leak coming from the front of the motor where the front drive shaft goes in? I had this fixed when the bike was under warranty. Now no warranty so I'd like to fix it myself, hopefully. My front drive shaft is currently laying on the floor, I just don't know where to go from here.
 

·
Registered
Joined
·
59 Posts
i've replaced a few of these seals, not hard at all. if you alread have the drive shaft out then take a flat head screwdiver or something with a hook on it to pull the seal out. what ever you do don't push it farther into the motor, a pain to get out. then to install the new seal i took a socket a tad bit smaller than the seal and tapped it in flush with the motor. reinstall the drive shaft and call it done...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top