Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
I just installed a Highlifter BBK and had my heads ported decked and polished. I have a K&N filter with a stock muffler. Can anyone tell me what jet I should use to get me close to running smooth?
 

·
Registered
Joined
·
262 Posts
well if you have a jet kit i would think around a DJ134 -138, stock would be the same. the main jet only meters gas at high rpms the bike will run if you leave it out and only go to 3/4 throttle. thats where the needle and pilot jet screw come in .
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top