Honda Foreman Forums banner
1 - 4 of 19 Posts

· Registered
Joined
·
1,472 Posts
I have to drive around for a while with the choke on too.I have a cylinder temp. gauge on mine and it doesn't start to run good until around 250 degrees. It's been cold here the last couple weeks,temps. in the teens.
 

· Registered
Joined
·
1,472 Posts
I always have to pump the primer if it's been sitting for a while(more than a week).
 

· Registered
Joined
·
1,472 Posts
Pull off the side cover on the right side and look up to the carburetor,you'll see a black knob sticking out the right side of the carburetor,that's the primer.
 

· Registered
Joined
·
1,472 Posts
QUOTE ("JWJR":5qacb14f)
is that right side as in gas side or on the other side
That's right side when you're sitting on the ATV.There's a plastic cover that you remove to get to your pull start cord,That's the same cover to access the primer.
 
1 - 4 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top