[Madd_mat]

I have change de angle sensor now i have no red lights and "R" when i put to reverse

 

[bc buck]

Download free service manual and verify sensor was installed correct.

 

[Madd_mat]

I have make the procedure en reset to be done!!!

 

[Madd_mat]

I found the trouble I have no ground signal at the gear position switch when I put to reverse the result is no reverse light no "R" on the screen and when I back up he was in limp mode !!!!

 

[bc buck]

What next step

 

[Madd_mat]

What next step

Change the gear position switch !!! She is located over the drive shaft on the rear of the engine !!!

 

[bc buck]

Let us know how tuff to do. If just a open/close switch should be able to jump to verify problem.

 

[Madd_mat]

Very simple it's all in the shop manual section 24