Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
13,198 Posts
turning the ignition switch off will reset the computer for temp. codes. to initialize the computer have the switch off, trany in neutral, and mode select switch in D1 or D2. hold both the up and down shift buttons and turn the switch on. then release and press up - down - up , move the throttle lever from fully closed to fully open and then back to fully closed. this all has to be done pretty fast and should here the control motor cycle.
 

·
Premium Member
Joined
·
13,198 Posts
We have been chatting about this already. Did you remove the angle sensor? If so did you get it pre loaded when installing it again? I've been trying to find something on that "out of place" connector but I will have to look through the manual tomorrow when I get to work (PDF is taking too long to navigate around).
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top