Honda Foreman Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
240 Posts
well u can take off the lock nut and take a small wire brush on a dremal tool and shine up the treads on the nut/bolt reinstall with grease . the ajustment is very small and removes the play of the triangle bearing plate that opens the clutch bands when u shift it wears very little about one MM or two over time .
i had to remove the clutch cover to install clutch springs and a cam so i cleaned mine that way about a 2 or 3 hour job but not bad.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top