Honda Foreman Forums banner

High Lifter Springs(install)

1947 Views 4 Replies 3 Participants Last post by  rollingthunder
I have a 2006 Rubicon and I'm getting ready to install High Lifter
Springs, front and rear, did purchase the spring tool.
My question is how do you remove the retaining ring once the tension has
been taken off the spring.
Thanks for your help
Dan
1 - 5 of 5 Posts
It slides right off, there is a slot that allows it to pass the shaft.
Thanks for the reply,
The way I understand it, is when I compress the shock the plastic shock
cover will also slide down exposing the shock "rod" where this slot should be
located to slide the retaining ring off.
Is this right.
Thanks for your help
Dan
Correct sir, I did it on my 07 rubicon. I did the springs with ratchet straps thought. I put the lift in as well while I had the shocks out.
Thank you very much for the information, springs should be here sometime
next week, sounds like it should go fairly easy.

Thanks again
Dan
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top