Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
I made one out of 1" square tube for the uprights and 2" steel channel to attach the 2 frames together. Used 1/8" flat stock and made braces on the corners......all welded and attached to front and back with U-bolts. It weighs about 35 lbs and does make the bike a bit top heavy with the canoe on, but you just have to taker a bit easier........
 

·
Registered
Joined
·
6 Posts
I made mine so it sits about 35" high from the top of the front and rear racks. The stock is cut at 36" but angled at about 10 degrees so it's narrower at the top. I had thought about dropping the back end too but figured it would be too low for taking a passenger. Attaching it with the U-bolts makes for quick on and off, depending on what kind of riding I'm doing. Good luck with yours.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top