Honda Foreman Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
12 Posts
bearing

I concur, it will be a lot cheaper to replace the bearing rather than the knuckle and bearing. I used a brass punch to get mine out, but if you are unsure, take the knuckle off (two ball joints and the tie rod) and take it to a shop that can press them out with a hydraulic press. It really is a piece of cake.
d
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top