Honda Foreman Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #3 ·
It seems to be stripped in the coupling joint that comes off the engine. When I took it apart the spring inside was busted in half and the rubber boots that attach to the joints are also gone. If i jack it up on jackstands the driveshaft works fine, but when I set it down on the ground the weight causes the driveshaft to slip in the joint. The side of the joint that attaches to the engine output shaft work fine.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top