Honda Foreman Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,679 Posts
no it will not fit, they are too different lenghts. Is it just the driveshaft itself that is stripped? If so I have one for a 98 foreman 400, but I dont have the couplings to go with it.
 

·
Registered
Joined
·
13 Posts
Discussion Starter · #3 ·
It seems to be stripped in the coupling joint that comes off the engine. When I took it apart the spring inside was busted in half and the rubber boots that attach to the joints are also gone. If i jack it up on jackstands the driveshaft works fine, but when I set it down on the ground the weight causes the driveshaft to slip in the joint. The side of the joint that attaches to the engine output shaft work fine.
 

·
Registered
Joined
·
2,679 Posts
Sorry hmiller79 I didn't see that you responded to the post. I have been alittle busy lately. Where are you located? How's $30 shipping sound.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top