Not a big job .. We stand the bike on the rear tires & rear rack (turn fuel off and pinch fuel cap breather) ..Remove front wheels , unbolt (3) mounts for front differential and slide if forward and tie it .. Using a prybar pop the drive shaft joint off the motor .. Then using a pick/screwdriver dig the old seal out (careful not to mark the output shaft) .. Replace the seal keep it square as your tapping it in place ..
Front Drive Shaft
Has anyone had to do a front drive shaft seal at the motor end if so was it very involved??
Thanks
Chris
Thanks
Chris
1 - 3 of 3 Posts
Good advice
That's sounds like a quick way of doing it.
That's sounds like a quick way of doing it.
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda Foreman Forums
Honda Foreman Forums: Discuss the latest Honda Foreman in our free Honda Foreman forums. Also talk about Honda's other ATV and UTV's including the Honda Rubicon, Honda Rincon, Honda Rancher and Honda Recon
Full Forum Listing
Explore Our Forums
Recommended Communities
