Honda Foreman Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
So i recently put some 31 outlaws on my 2007 foreman and pretty much had to remove the floorboard support brackets that go along the inner front fender. Does anyone make metal floorboards for these bikes and if so where can I get some. If not I suppose I'll build some myself.
 

·
Premium Member
Joined
·
2,041 Posts
Floorboards just slow ya down in the mud and if you have 31" outlaws im guessing you really like mud.. lol why not remove them and use a dirtbike type foot peg..
 

·
Registered
Joined
·
16 Posts
Discussion Starter #3
It has those already. The only problem with them is they lack a lot of surface area and when transitioning from side to side in a mud hole my foot could slip through. Outlaws turning in mud don't feel too good on a foot or ankle.
 

·
Premium Member
Joined
·
6,228 Posts
Hammer back the factory supports in the front, put a 450 Foreman swing arm, driveshaft, and right axle tube in the rear for a 2.5 inch stretch and you should be able to run factory floorboards.


If you want metal ones try Strongmade. I think they're the only company currently making them. I'll bet 450 Foreman would fit.
 
1 - 4 of 4 Posts
Top