Honda Foreman Forums banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
1,740 Posts
Discussion Starter · #1 ·
Well I figured I have all of thisfree time I might as well put it to good use. I have an old diamond plate tool box I am going to make into full skid plates, but I also want to make front and rear bumpers but I don't know what I should make them look like.
So my question is do any of yall have any good pictures of bumpers that are being manufactured or homemade I need to get some ideas.


Thanks

Neil
 

·
Premium Member
Joined
·
1,740 Posts
Discussion Starter · #4 ·
The only thing that I would plan out pretty well is where the plate bolts up on the bottom, the bolts are recessed in the skid plate in the skid plate. If you are going to use something that thick you might have a problem bending it in you might want weld some kind of spacer to it where the bolts go or jsut get a big hammer and beat the **** out of it.
 

·
Premium Member
Joined
·
1,740 Posts
Discussion Starter · #6 ·
I thought of doing that but I didn't know if it would act like a shear and cut the metal so I just bent the metal in with a hammer and then drilled the holes.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top