[GUMP NAZTY]

I NEED SOME HELP FROM A PRO! MY RIDE IS A 03 FOREMAN RUBICON AND IM HAVIN MAJ ISSUES. WHENEVER I SHIFT INTO D GIVE IT SUM GAS MY POD LIGHTS KEEP BLINKIN LIKE CRAZY AND IT SEEMS LIKE ITS IN 1ST GEAR AND WONT COME OUT. IT DONT MATTER IF ITS IN ESP,D2,OR D1.I TOOK THE BATT LOOSE AND IT DIDNT HELP,ANY IDEAS ANYBODY???[/b]

 

[aaron_c]

If it's blinking, I think it's giving you a trouble code. You need note how many blinks there are, and any pauses etc.

 

[GUMP NAZTY]

I JUST FOUND OUT HOW TO DO THE TEST AND IT BLINKS 7 TIMES AND PAUSE 7 TIMES,ANY IDEAS?

 

[Honda Mechanic]

Code #7 is the "up/down shift button code" .. You should check the coupler for the left handlebar switch , it is on the left side just in front of the fuel tank .. It is a 10p coupler and it should be checked for moisture then cleaned & greased with dielectric grease ...

 

[GUMP NAZTY]

OK,I CLEANED THE CONN AND IT FAILED. HOWEVER IT FLASHES 3 TIMES THEN 7 TIMES WHAT DO YOU THINK?

 

[hondaman5002002]

you need to reset the ECM after you cleaned it first then try it.

 

[Honda Mechanic]

Code #3 is gear position switch system ( L, D , N , R) or relater wire harness .. You should clean & re-grease all the ESP couplers on the bike .. Then erase the stored codes , then initialize the ECM and test the bike again ...

 

[GUMP NAZTY]

i SPRAYED THE CONNECTIONS WITH SOME STP WIRE DRER AND LET THEM SIT FOR ABOUT AN HOUR THEN PUT NEW GREASE IN THEM.I RESET THE COMPUTER AND IT WAS FINE FOR ABOUT 5 MINS AND DONE THE SAME THING,THEN DONE THE PROCEDURE AGAIN AND THE SAME OUTCOME.

 

[Honda Mechanic]

You will have to follow the Hondamatic flow chart test chart for the bike ... Do you have a shop manual with the tests ..?

 

[GUMP NAZTY]

YES,I JUST BOUGHT ONE.I TRIED RESETTIN THE COMPUTER LIKE THE BOOK SAID BUT IT ISNT WORKIN.