Honda Foreman Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
Does anyone know why you have to drill the slide lift on the 97 400 kit? I was thinking about getting the kit, but was uneasy about the thought of drilling something, especially in the carb. Is is a very critical job or, just drill it out?
 

·
Registered
Joined
·
67 Posts
it's a very easy job the drilling is not technical just a small hole
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #3 ·
What does the drilling do? Does it give good results? Like, actually do what it says? Sorry for all the questions, just want to make sure I do my homework. Thanks.
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #4 ·
Well got the jet kit installed with no problems... but I had to bring the idle mixture screw back to 3 turns out. The kit listed 2.5 turns. Also they sent me the wrong precharger for my K&N.
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #5 ·
When I turned the idle jet back out to 3 turns it seemed to be running better and it didn't smell hot anymore. I did end up pinching the choke plunger's plastic seal when I was reinstalling it. Would that maybe cause it to be running a bit rough? It is surging a bit and sometimes stalls.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top