Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
While doing the PM, I ran the Rear Diff drain plug in by hand. However, I must have cross threaded it because now it won't tighten up all the way.

I'm so mad at myself!!! Anyhow, how should I fix? Right now, it's appears that it's tight enough to not leak but I'm not sure. I did put some blue colored Tightner on the back half of the bolt.

Any thoughts on how to fix? Thanks
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #4 ·
After about 30 miles and 2 hours of hard use, the Blue Loctite is holding fine, no leaks, etc. In 2 - 3 years when it needs done again, I'll run it in and have the shop retap it properly.

Thanks to all for the input.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top