Honda Foreman Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Got new aluminum wheels and tires for christmas and was mounting them
tonight i was told to torque them at 100 foot pounds by a local atv dealer
and broke a stud. Defective stud or to tight,all the other ones held up fine.
any suggestions.
 

·
Registered
Joined
·
2,072 Posts
i would replace the stud

and if you happen to have a 500 foreman you cant buy just the stud you have to buy the whole hub assembly....$33-rear,$38- front(and specify which side because it does make a difference)
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
I called my honda dealer this morning and he told me the good news about having to buy the hub and not just the stud. Im from Canada and
its $98. anyone know about aftermarket studs that might be stronger.
 

·
Registered
Joined
·
68 Posts
Stock is only 57lbs. I would think that you would not have to go much more then that, but you would have to retighten them a couple times. After that you should be ok, but what do I know.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top