Honda Foreman Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
183 Posts
Discussion Starter · #1 ·
Hey guys i was just wondering if you think it would be cheaper to have a machine shop make me a aluminum belly plate? i would just call and check but i thouhgt i would ask you first.
Thanks
 

·
Registered
Joined
·
3,444 Posts
I talked to a comapny who makes things out of plastics. Everything from storage boxes and winsheilds from boats to lexan hurricane shutters. He said it would be over $200 to make/design one out of starboard. Plus the cost of material. There is a lot of work and time involved designing good skid plates. In the long run you will be better off buying one, in my opinion.
 

·
Registered
Joined
·
68 Posts
You would be better off just getting an Aluminum Products belly pan.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top