Honda Foreman Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
162 Posts
Discussion Starter · #1 ·
i am working on my uncles 2000 model foreman 400, i need to replace the upper ball joints, but i noticed at work that honda wants you to order the complete arm? is there a way around this?
 

·
Registered
Joined
·
162 Posts
Discussion Starter · #2 ·
i found them, they are the same as the lower ball joints on a trx350 rancher 00-04 models.
 

·
Registered
Joined
·
2,694 Posts
yea only honda would do something like that, I have a shop close that carries aftermarket ball joints. They should be the same as a 300 also
 

·
Registered
Joined
·
162 Posts
Discussion Starter · #4 ·
yea that is the most stupid thing i have seen. when i looked them up at work honda wants you to cahnge the whole arm, but i looked online and found out they were the same as a trx350 rancher lowers, and i think the 300's. Dirty, we need to get together and ride sometime, you need to go to Rabbit Creek may 5-7 for the ride, my riding group MudMafia is going. check out there site: <a href="http://www.baddrabbit.com/" target="_blank">http://www.baddrabbit.com/</a>

i have new pics and videos up on the site from gator run, that is a good place to go also and there is some from rabbit creek also so you can see whats all there.
 

·
Registered
Joined
·
2,694 Posts
Yes we need to hook up, but not going to be able to make it with such short notice. We have made plans for a trip on May 26-29 for the Sabine River Rat Ride in Marshal TX. Maybe next time, thanks for the invite.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top