[aastelly]

i used 1-1/2'' spa flex then connect it to to 2'' pipe when i got to the A arms, no problems with lose of flow.

 

[aastelly]

this is how i ran my snorkel, the paint is KRYLON spray paint, just before you paint wipe down the stuff to be painted with pvc cleaner the paint will stick better, straight from air box with 1 1/2' flex up to 2" pvc fittings route them how you like. i also cut some 2'' pvc in half and put it over the flex by the motor. 1 shorty for trail riding just screw on tall one when goin deep.
use tread tape on treads also called "T TAPE" i bungie the tall one between the front rack and plastic.
note the bearing grease to help seal the air box.
the only hole i cute was the one through the fender.
hope this helps...

 

[aastelly]

the flex hose is called "spa flex" i got if from LOWES, i used 1 1/2" flex so i would not have to cut the in side fender. just use a 1 1/2" to 2" bushing from the flex to the hard pipe. mine runs just fine with 1 1/2" up to 2". some people say that 1 1/2 all the way gives them problems. i used the 1 1/2 in my air box just put some silicone on the hose then tighten the clamp. if anything else just ask.

 

[aastelly]

the pics were taken before i wiped the over spray off with paint thinner.
i was just goin to leave it white but after seeing it on it looked funny white.


IF ITS NOT ZIP TIED OR DUCT TAPED ITS NOT RIGHT

 

[aastelly]

use krylon spray paint its made for plastic, thats what i used, it hasn't chipped off so far. just wipe it down with pvc cleaner before painting. the directions say use paint thinner.