count the flash pattern and get back to us, is it 350 or 400CC?

 

If you have the 400AT and you replaced the angle sensor, you will need to perform the initial setting procedure, if you haven't already.

 

thanks!

tried the instructions i was given to perform the reset but didn;t work ...nothing is flashing on the display just the " " ??
thanks for the help guys !

 

?

helmut,
do you have that procedure ? maybe i was given the wrong one ??
thanks,mike

 

This is on a 400AT??? Was the sensor installed correctly (preloaded)?

 

what do you mean when when you say pre loaded ?? thanks,mike
i had a friend do it who is pretty knowledgeable with the hondas....
its a rancher 400
thanks

 

Angle Sensor Replacement and Preload




Initial Setting Procedure

 

ok

did everything correctly ...i think ....looks like its now blinking 6 1
anyone know what that means ??
thanks!!!!!!!!

 

 

reverse is popping and not moving either ....so if i get a 6 short blink and 1 long blink
does that mean both sensors on the chart above are messing up ?
thanks guys

 

It doesn't necessarily mean that the sensors are bad when it indicates a code, it just means there's a problem in that particular system or circuit. For example, code 6 (angle sensor system) could be a bad angle sensor or it could be a bad wire or bad connection or anything else in that circuit. When you get more than one code, the first code is the most recent problem. Download the service manual and go to the "Hondamatic" section and it will show you how to troubleshoot the problem for each code stored in the computer. Here's the link for the service manual.

2004-2007 Rancher 400AT Service Manual

 

i might

just have to take it to honda ....looks like its beyond me ....
thanks so much for all the help !!!

 

......

well ...called honda ....2 week wait so i guess i might still play with it .
when i installed the angle sensor not really sure if i did it right it seems the like the sensor was not touching the shaft ....not really sure how to pre load it if its not touching the shaft ?

 

ok.....soooooo

changed the angle sensor and it its still doing it .....brought it to honda and they are saying everything looks ok but they seem to think its the centrifugal clutch ....they seem to think its being held back because its actually shifting when it shouldnt be ....i might have misunderstood but i
basically they say its the clutch starting to wear out ????