Honda Foreman Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter · #1 ·
anybody know the correct toe adjustment and any tricks for doing it???
finally got bike back together and the steering is pretty off and harder to turn than i remember.
 

·
Registered
Joined
·
213 Posts
Check tire pressure all around. Check for bent or binding linkage.
Check for bindng in the steering shaft (jack up front end and steering should turn easily) if it is binding it may be bad bearings in the steering shaft, or shaft too tight.

With the machine on level ground and all four wheels on the ground, handle bars straight ahead, Tires straight ahead. Mark the center of each front tire in the front. Measure the distance then roll the machine until the tires have turned 180°. Measure the distance across the back.

Adjust to 1-3/8" toed OUT. (plus or minus 9/16")
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top