2006 foreman 500s

2424 Views 6 Replies 5 Participants Last post by Robb, May 23, 2006

sthamby

Discussion Starter · May 17, 2006

i have a 2006 foreman 500s and i was wondering if i had a fender kit and a highlifter lift kit could i fit 28x10.5 outlaws and would i be able to turn them good in first gear plus i dont want my tires to scrub at all

Save

1 - 7 of 7 Posts

Robb

· #2 · May 17, 2006

i can fit 29.5 Outlaws with no lift or fender kit, 28s shouldnt have to much trouble. I had to bend the stock fender brackets in, and take a heat gun to my rear fenders a little:

The only time mine rub is hitting a bump going faster then I should, the front hae rubbed a few times.

See less See more

Save

MUDLABSPECIALIST

· #3 · May 17, 2006

Yea you will definelty have to bend the front brackets in and trim the rear fender a little.

Save

SASQUATCH

· #4 · May 17, 2006

Lol dang robb. Thats pure *******! Awsome

Save

Robb

· #5 · May 17, 2006

QUOTE ("SASQUATCH":1chtlkgq)

Lol dang robb. Thats pure *******! Awsome

hehe ...I did have a lift kit on it, but I was having enough problems keeping parts together...

Save

ROWDYFOREMAN

· #6 · May 23, 2006

I HAVE 28X10 OUTLAWS AND I HAVE TROUBLE TURNING THEM IN 2ND GEAR WHILE IN THE MUD. SOMETIMES IN 1ST GEAR IN NASTY MUD. DO YOU HAVE ANY TROUBLE. I'V INSTALLED A CLUCTH KIT BUT HAVENT HAD CHANCE TO TRY IT OUT YET, WILL THIS HELP..

Save

Robb

· #7 · May 23, 2006

yeah mine isnt going to do crap in 2nd gear, unless its not very deep mud, I have to use 1st gear all the time.

Save

1 - 7 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month