Honda Foreman Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
hi all yes i'm a newbie, but anyhow i need some advice the jug on my foreman has a couple rough spots in it i had the jug bore checked,it read from top 3.533 middle 3.536 bottom 3.539 should i just hone it out or bore
it if you can bore it.. or is the best thing to resleeve it. thank you all


foreman
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top