Honda Foreman Forums banner
1 - 16 of 16 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hello all hope all is well !! I’m new and have a question about my 03 rubicon 500 , I just picked it up the other day used for cheap , but it has no spark and on the dash D1,D2and ESP are showing but only two dashes where neutral (N) should be showing , the guy I got it from said he was riding and it just cut off and has no spark , I have replaced the angle sensor ( followed the pre charge instructions) replaced the voltage regulator, still nothing !!! Any ideas would be awesome thanks !!!
 

· Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
I have tried to get it to show codes but i can’t seem to get it to show anything, I’ve looked online on how todo the correct procedure but still can’t get it to work !! Thanks for your response
 

· Registered
Joined
·
8 Posts
Discussion Starter · #7 ·
I’m leaning heavily towards the cdi box due to no spark and the dash is not working properly!! Not N on the dash and I’ve tried the code thing multiple times and nothing I don’t even hear the noise that it says to listen for !! Thanks
 

· Registered
Joined
·
3 Posts
mine did same thing ended up being sensor on side of carb...2002 rubi500
Mine is doing the same thing and I was about to buy the ECU…but I also JUST replaced the carb before it stopped getting spark…so now I’m thinking this is a likely cause, or just extremely convenient timing…how do I check that sensor to diagnose or rule this out??
 
1 - 16 of 16 Posts
Top