I am doing a top end rebuild on an 01 rubicon. I found TDC and installed the camshaft with the “line” marking on the gear in the down position. The motor won’t start sounds like it’s in the wrong spot. Also I had the head bored and install a 93.00mm piston and ring.
So you have the T mark lined up with the index mark on the rear cover to locate TDC? As long as it is, then the cam timing mark should be down & even with the top of the cylinder.
If so, then the cam timing is correct and you should verify the valve clearances.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
Honda Foreman Forums
Honda Foreman Forums: Discuss the latest Honda Foreman in our free Honda Foreman forums. Also talk about Honda's other ATV and UTV's including the Honda Rubicon, Honda Rincon, Honda Rancher and Honda Recon
