Honda Foreman Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 20 Results
  1. Rubicon 500
    We just bought a 2018 Rubicon with 18,500 miles on it. The engine is as quiet as anything I own and everything works perfectly DCT and EPS included. It’s in desperate need of tires but I’m excited to get working on it and with it. So if anyone is worried about having a few thousand miles on...
  2. Foreman 450
    Picked up a 02 Foreman 450ES in a trade this weekend. Got it running so I took it for a quick spin. Took off in first, hit second gear, then third and when I went to shift to 4th I had to let off the throttle and slow nearly to a stop before it would shift up. Same thing from 4th to 5th as well...
  3. Tire & Wheel Discussion
    Hey all, new here from Mississippi. I’m looking to get new tires and wheels for my 2012 Foreman 500. Can I fit 28-9-14s all around without cutting the rear fender? Any advice helps. Looking at Outlaw 3’s at the moment because of a great price I can get them for. Only use the bike to hunt with...
  4. Foreman 450
    Would anyone be able to send me the measurements for the bar that goes over the battery and has the latch bar for the seat? I'm going to just make one given a replacement is around 100 bucks. A little ridiculous.
  5. Foreman 500
    So... someone put diesel in my tank instead of gas (might have been me, but blaming it on my son who put diesel in a red gas can!) I am having difficulty locating the gas line. Can someone provide pictures? So far, can't find any YouTube videos on how to locate it. Is there a 'best way' to...
  6. Foreman 400
    So about a month ago I bought a 02 foreman 400. trx400fw (if relevant) didn’t have much experience with wheelers before all this, and am kinda stuck now. Previous owner 100% sunk it and he said it sat for about a year. Wheel bearings where shot. Back breaks were locked up. Solved those issues...
  7. Foreman 450
    So I have a 98 foreman 450es. It needed a top end and many other things when I got it, so I ordered a wiseco top end kit with a niche cylinder, which is what was in it before. Followed all the procedure and put the kit in, went to fire it up and it popped off but wouldn't run, seemed like it had...
  8. Foreman 500
    Hey everyone. First post on anything other than FB so I hope I’m following protocol. I have an ‘05 Foreman S that sat for 6-7 years. Bought it from a kid that sunk it. Installed new carb and cylinder and piston. New battery too. Fired it up and it ran fine for a few minutes. Acted like it wanted...
  9. Honda Rancher 350, 400 & 420
    I have a 2006 honda foreman that I recently replaced rings and valve seals on. The bike had been smoking a little and had noticed a pinging noise after riding for a while. Decided to try and adjust the valves but could not get the exhaust valve to adjust out. Seemed like it had way too much...
  10. Rubicon 500
    Hello everyone. My 04 foreman rubicon has been giving me a crap ton of problems and I’m at a loss of what’s the problem. I’m aware that code 05 is with the angle sensor. I’ve at this point bought 3 angle sensors, and preloaded them each, and reset the computer each time with no difference, my...
  11. Foreman 400
    Hi all, Wanted to make this post as I wasn’t able to find much in the way of information when I encountered my issue. The issue I had was my speedometer, odometer, and Trip meter had stopped working, but the hour meter was fully functional. For reference, this is on a 1999 Foreman 400 S foot...
  12. Foreman 400
    Hi Guys, I'm new to the forum and from Ireland And looking for some help. I have a Honda Foreman 400 FW going 100%. The only thing is I need to get a new muffler for it as the existing one, the silencer inside is gone and the quad had become quite loud. I'm looking to replace this but cannot...
  13. Foreman 400
    (back story) I've recently picked up what appeared to be a nice foreman 400 to pick up a new hobby. It hasn't given too many problems until now. Ended up taking on some "pull your boot off mud" and had to be winched out. While hooking up the winch, the foreman stalled and refused to turn over...
  14. Foreman 500
    i have a 2005 honda foreman 500 es 4x4 and was wondering what years/style of motors i could swap in as ive got it to its last leg at this point 😂
  15. Foreman 500
    i have a 2006 Honda foreman 500 electric shift and am having some trouble with it getting stuck in gear. Sometimes it will be perfectly fine and i can ride as hard and long as i want with it and it will be fine but sometimes it will randomly get stuck in any gear. When this happens the gear...
  16. Foreman 500
    I've narrowed the problem on my foreman 500 down to the first gear is going,clunks and pops while driving but is fine 2nd and up. Gonna replace the gear,can it hurt it to drive it with just 2nd? heard on here 1st is really only needed for towing.Anyone have a link to where I can get the gear...
  17. Foreman 450
    Hi all, I’m new to the forum so sorry for any errors, I have a 1998 Honda foreman 450. When the engine heats up and I apply full throttle it sometimes smothers itself only giving me 1/2 power. Sometimes if I let off the throttle it will come back right straight away. Sometimes it completely...
  18. Foreman 450
    I’m wondering if anyone has put 30x9x14 silverbacks on a stock foreman the rims are off of a brute force with the same pattern wondering if they will fit before I buy them, or will I need to lift the quad?
  19. Foreman 500
    What would make a 2018 Foreman sputter above half throttle, especially when going up an incline? I have not had time to check it out yet, but my first suspects would be to check the plugs, wires, air filter, and fuel filter. If that is not the issue, I will check the valves to ensure proper gap...
  20. Foreman 500
    Hey guys so i picked up a bike and the start button does not engage at all. No click or anything.... i can cross the solenoid and get it to start fine so i wasn’t sure what the issue was. I replaced the battery, starter, put a brand new solenoid in and even took apart the bar controls to blow...
1-20 of 20 Results
Top